产品描述
SIEMENS西门子SIMATIC S7-200|6ES72881ST300AA1标准型
SIEMENS西门子SIMATIC S7-200|6ES72881ST300AA1标准型
SIPLUS IM 155-5 DP
6AG1155-5BA00-2AB0 SIPLUS ET 200MP IM155-5 DP ST 基于 6ES7155-5BA00-0AB0 带防腐蚀涂层, -40 - +60°C, -25°C 条件下开机, PROFIBUS 接口 针对多 12 个 S7-1500 模块 |
用于将 ET 200MP 连接到 PROFIBUS 的接口模块
在 PLC 中处理与 PROFIBUS 主站的数据交换
多 12 个 I/O 模块
自动通信速率 9.6 kBit/s... 12 MBit/s
PROFIBUS 地址 1 ... 125;可使用 DIP 开关进行调节
标识和维护数据 IM0 ... IM3
注意:
SIPLUS extreme 产品基于 SIMATIC 标准产品。此处列出的内容来自相应标准产品。增加了与 SIPLUS extreme 相关的信息。
使用 IM 155-5 DP ST 接口模块,可将 ET 200MP 连接至 PROFIBUS,并自动处理模块和上层 PLC PROFIBUS 主站之间的通信。
IM 155-5 DP ST 接口模块可用螺丝直接固定到 S7-1500 安装导轨上。IM 155-5 DP ST 具有以下功能:
错误 (Error)、运行 (RUN) 和维护 (MAINT) 诊断显示。
使用 9 针 SUB-D 连接器连接至 PROFIBUS;供货范围内包括一个 6ES7972-0BB70-0XA0 型 PROFIBUS 连接器。
24 VDC 电源模块用于连通电源电压。
使用锁、封条或电缆扣,针对未授权的访问为接口模块提供保护。
Article number | 6AG1155-5BA00-2AB0 | |
---|---|---|
SIPLUS ET 200MP IM155-5 DP ST | ||
General information |
| |
Product type designation | IM 155-5 DP ST | |
HW functional status | 01 | |
Firmware version | V2.0.0 | |
Vendor identification (VendorID) | 81AAh | |
Product function |
| |
● I&M data | Yes; I&M0 to I&M3 | |
Engineering with |
| |
● STEP 7 TIA Portal configurable/integrated from version | see entry ID: 109746275 | |
Supply voltage |
| |
Rated value (DC) | 24 V | |
permissible range, lower limit (DC) | 19.2 V | |
permissible range, upper limit (DC) | 28.8 V | |
Reverse polarity protection | Yes | |
Mains buffering |
| |
● Mains/voltage failure stored energy time | 5 ms | |
Input current |
| |
Current consumption (rated value) | 0.2 A; at 24 V DC and without load | |
Current consumption, max. | 1.2 A; at 20.4 V DC and max. load | |
In current, max. | 4 A | |
I²t | 0.09 A²·s | |
from interface 5 V DC, max. | 80 mA | |
Power |
| |
Infeed power to the backplane bus | 14 W | |
Power loss |
| |
Power loss, typ. | 4 W | |
Address area |
| |
Address space per module |
| |
● Address space per module, max. | 128 byte; per input / output | |
Address space per station |
| |
● Address space per station, max. | 244 byte; per input / output | |
Hardware configuration |
| |
System power supply can be plugged in to left of IM | No | |
Number of permissible power segments | 1 | |
Rack |
| |
● Modules per rack, max. | 12; I/O modules | |
Interfaces |
| |
Number of PROFIBUS interfaces | 1 | |
1. Interface |
| |
Protocols |
| |
● PROFIBUS DP slave | Yes | |
Interface types |
| |
RS 485 |
| |
● Transmission rate, max. | 12 Mbit/s | |
Protocols |
| |
Open IE communication |
| |
● TCP/IP | No | |
PROFIBUS DP |
| |
Services |
| |
— SYNC capability | Yes | |
— FREEZE capability | Yes | |
— DPV1 | Yes | |
Interrupts/diagnostics/status information |
| |
Status indicator | Yes | |
Alarms | Yes | |
Diagnostics function | Yes | |
Diagnostics indication LED |
| |
● RUN LED | Yes; green LED | |
● ERROR LED | Yes; red LED | |
● MAINT LED | Yes; Yellow LED | |
Potential separation |
| |
between backplane bus and electronics | No | |
between PROFIBUS DP and all other circuit components | Yes | |
between supply and all other circuits | No | |
Permissible potential difference |
| |
between different circuits | 75 V DC/60 V AC | |
Isolation |
| |
Isolation tested with | 707 V DC (type test) | |
Ambient conditions |
| |
Ambient temperature during operation |
| |
● horizontal installation, min. | -40 °C; = Tmin (incl. condensation/frost); start-up @ -25 °C | |
● horizontal installation, max. | 60 °C; = Tmax | |
Altitude during operation relating to sea level |
| |
● Ambient air temperature-barometric pressure-altitude | Tmin ... Tmax at 1 080 hPa ... 795 hPa (-1 000 m ... +2 000 m) // Tmin ... (Tmax - 10 K) at 795 hPa ... 658 hPa (+2 000 m ... +3 500 m) // Tmin ... (Tmax - 20 K) at 658 hPa ... 540 hPa (+3 500 m ... +5 000 m) | |
Relative humidity |
| |
● With condensation, tested in accordance with IEC 60068-2-38, max. | 100 %; RH incl. condensation / frost (no commissioning in bedewed state), horizontal installation | |
Resistance |
| |
Coolants and lubricants |
| |
— Resistant to commercially available coolants and lubricants | Yes; Incl. diesel and oil droplets in the air | |
Use in stationary industrial systems |
| |
— to biologically active substances according to EN 60721-3-3 | Yes; Class 3B2 mold, fungus and dry rot spores (with the exception of fauna); Class 3B3 on request | |
— to chemically active substances according to EN 60721-3-3 | Yes; Class 3C4 (RH < 75%) incl. salt spray according to EN 60068-2-52 (degree of severity 3). The supplied connector covers must remain on the unused interfaces during operation! | |
— to mechanically active substances according to EN 60721-3-3 | Yes; Class 3S4 incl. sand, dust. The supplied connector covers must remain on the unused interfaces during operation! | |
Use on ships/at sea |
| |
— to biologically active substances according to EN 60721-3-6 | Yes; Class 6B2 mold and fungal spores (excluding fauna); Class 6B3 on request | |
— to chemically active substances according to EN 60721-3-6 | Yes; Class 6C3 (RH < 75 %) incl. salt spray acc. to EN 60068-2-52 (severity degree 3); * | |
— to mechanically active substances according to EN 60721-3-6 | Yes; Class 6S3 incl. sand, dust; * | |
Usage in industrial process technology |
| |
— Against chemically active substances acc. to EN 60654-4 | Yes; Class 3 (excluding trichlorethylene) | |
— Environmental conditions for process, measuring and control systems acc. to ANSI/ISA-71.04 | Yes; Level GX group A/B (excluding trichlorethylene; harmful gas concentrations up to the limits of EN 60721-3-3 class 3C4 permissible); level LC3 (salt spray) and level LB3 (oil) | |
Remark |
| |
— Note regarding classification of environmental conditions acc. to EN 60721, EN 60654-4 and ANSI/ISA-71.04 | * The supplied plug covers must remain in place over the unused interfaces during operation! | |
Conformal coating |
| |
● Coatings for printed circuit board assemblies acc. to EN 61086 | Yes; Class 2 for high reliability | |
● Protection against fouling acc. to EN 60664-3 | Yes; Type 1 protection | |
● Military testing according to MIL-I-46058C, Amendment 7 | Yes; Discoloration of coating possible during service life | |
● Qualification and Performance of Electrical Insulating Compound for Printed Board Assemblies according to IPC-CC-830A | Yes; Conformal coating, Class A | |
Dimensions |
| |
Width | 35 mm | |
Height | 147 mm | |
Depth | 129 mm | |
Weights |
| |
Weight, approx. | 360 g |
SIEMENS西门子SIMATIC S7-200|6ES72881ST300AA1标准型
您是第292099位访客
版权所有 ©2024 八方资源网 粤ICP备10089450号-8
浔之漫智控技术(上海)有限公司 保留所有权利.
浔之漫智控技术(上海)有限公司 保留所有权利.
技术支持: 八方资源网 八方供应信息 投诉举报 网站地图手机网站
微信号码
地址:上海市 松江区 小昆山镇 荡湾村 广富林4588弄52号3楼
联系人:颜经理女士
微信帐号:X15021292620